Nylon Piping Cord for Socks — Specification, Uses and Sourcing Notes
Nylon Piping Cord for Socks: Specification, Uses and Sourcing Notes
Nylon Piping Cord is the version buyers specify for socks when the base material is fixed by performance rather than by price. This entry sets out what the material actually changes, which specification to write into the tech pack, and where the cost sits — the three questions that decide whether the item passes bulk approval.
What it is
Nylon gives piping cord its weight-to-strength ratio. In practice that means the trim behaves differently in cutting, in finishing and in wear: plating and coating adhesion must be tested on the actual base. Buyers who specify the material up front avoid the most common failure — an item that looks right on the sample card and behaves differently in bulk.
Typical specification
| Item | Piping Cord |
|---|---|
| Base material | Nylon |
| Standard size | 20 mm Width |
| Common finishes | Rainbow Iridescent Finish, Epoxy Doming, Antique Brass Plating |
| Processes | Epoxy Coating, Weaving, Heat Setting |
| Typical application | Socks |
| Related applications | Activewear, Shirts, Bras, Bridal Gowns |
| Test standard | EN 71-3 |
| Usual packing | 200 pieces per polybag, 10000 per carton |
Properties that matter in buying
- Dimensional stability — 2% allowance is built into the spec before cutting.
- Colour fastness — tested to EN 71-3 on the actual base material, not on a substitute.
- Mechanical performance — pull strength after 20 cycles or washes.
- Compliance — EN 71-3 documentation issued with the shipment.
- Consistency — the approved counter sample becomes the reference for every reorder.
Common uses
- Footwear
- Suits
- Blouses
- Backpacks
- Shirts
- Home Curtains
How to specify it
- Name the base material in the tech pack, not just the item.
- Fix the size and tolerance in writing before sampling starts.
- Approve a counter sample made from the actual bulk base material.
- Order the test report against the standard your market requires.
- Retain a golden sample at the factory and a second one with you.
Related reading
Related specifications on this site cover resin button, knitted elastic, piping cord, stud trim, and the processes most often paired with piping cord include injection moulding, warp knitting, anodising.
Share the programme details and we will propose two alternatives — one optimised for unit cost, one for lead time — and let you choose.
