Custom Badge — Nylon Fabric with Injection Moulding
We supply badge to garment factories and brands, built in Nylon Fabric with injection moulding for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is attachment strength, since a lost clutch loses the badge, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: shade variation within one carton, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | safety pin |
| Size | 50 mm |
| Base material | Nylon Fabric |
| Finish / process | Injection Moulding |
| Colour options | 6 Pantone-matched shades |
| Packing | carded |
| MOQ | 2000 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; CPSIA lead and phthalate testing |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Epoxy Dome — available on Nylon Fabric, quoted per position and per colour.
- Chrome Plating — available on Nylon Fabric, quoted per position and per colour.
- UV Printing — available on Nylon Fabric, quoted per position and per colour.
- Rose Gold Plating — available on Nylon Fabric, quoted per position and per colour.
- Heat Transfer Printing — available on Nylon Fabric, quoted per position and per colour.
- Anti-Rust Treatment — available on Nylon Fabric, quoted per position and per colour.
- Offset Printing — available on Nylon Fabric, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same attachment strength.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Which compliance documents do you provide?
We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.
How long does sampling take?
A first sample takes 10 working days, and each revision about 4 days.
Start your badge programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
