Custom Badge — Copper with Black Oxide
We supply badge to garment factories and brands, built in Copper with black oxide for denim and workwear programmes. On a trim like this the specification that decides the outcome is edge definition, because soft enamel lines blur below 1 mm, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | adhesive backing |
| Size | 25 mm |
| Base material | Copper |
| Finish / process | Black Oxide |
| Colour options | 24 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 5000 pieces per style per finish |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; EN 71 part 3 for decorative components |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Offset Printing — available on Copper, quoted per position and per colour.
- Die-Casting — available on Copper, quoted per position and per colour.
- Rose Gold Plating — available on Copper, quoted per position and per colour.
- Pantone Colour Matching — available on Copper, quoted per position and per colour.
- Brushed Finish — available on Copper, quoted per position and per colour.
- Mirror Polish — available on Copper, quoted per position and per colour.
- Rubber Coating — available on Copper, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with black oxide applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge definition.
FAQ
What is the minimum order?
Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
How long does sampling take?
A first sample takes 7 working days, and each revision about 3 days.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Start your badge programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
