Custom Badge — Brass with Soft Enamel Fill
We supply badge to garment factories and brands, built in Brass with soft enamel fill for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is attachment strength, since a lost clutch loses the badge, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | safety pin |
| Size | 25 mm |
| Base material | Brass |
| Finish / process | Soft Enamel Fill |
| Colour options | 16 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 5000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 25-50 days after approval |
| Compliance | GB 18401 safety classification with GB/T 29862 fibre labelling; CPSIA lead and phthalate testing |
| Ship to | Shanghai or Shenzhen (Mainland China) |
What buyers can customise
- Antique Brass Plating — available on Brass, quoted per position and per colour.
- Rhinestone Setting — available on Brass, quoted per position and per colour.
- Pantone Colour Matching — available on Brass, quoted per position and per colour.
- Gunmetal Plating — available on Brass, quoted per position and per colour.
- Beaded Detail — available on Brass, quoted per position and per colour.
- Injection Moulding — available on Brass, quoted per position and per colour.
- Rubber Coating — available on Brass, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with soft enamel fill applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same attachment strength.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
What is the minimum order?
Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 12 working days, and each revision about 5 days.
Which compliance documents do you provide?
We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.
Start your badge programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
