Custom Badge — EVA Foam with Brushed Finish
We supply badge to garment factories and brands, built in EVA Foam with brushed finish for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is edge definition, because soft enamel lines blur below 1 mm, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | sew-on holes |
| Size | 50 mm |
| Base material | EVA Foam |
| Finish / process | Brushed Finish |
| Colour options | 6 Pantone-matched shades |
| Packing | carded |
| MOQ | 3000 pieces per style per finish |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 25-50 days after approval |
| Compliance | GSO conformity with Arabic labelling; REACH nickel-release test for metal findings |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Stamping — available on EVA Foam, quoted per position and per colour.
- Anti-Rust Treatment — available on EVA Foam, quoted per position and per colour.
- Soft Enamel Fill — available on EVA Foam, quoted per position and per colour.
- Hard Enamel Fill — available on EVA Foam, quoted per position and per colour.
- Heat Transfer Printing — available on EVA Foam, quoted per position and per colour.
- Chrome Plating — available on EVA Foam, quoted per position and per colour.
- Die-Casting — available on EVA Foam, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with brushed finish applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge definition.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How long does sampling take?
A first sample takes 14 working days, and each revision about 3 days.
Start your badge programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
