Custom Badge — Cork with Sewn Edge
We supply badge to garment factories and brands, built in Cork with sewn edge for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is plating thickness, which decides how long the badge survives wear, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | adhesive backing |
| Size | 30 mm |
| Base material | Cork |
| Finish / process | Sewn Edge |
| Colour options | 6 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 2000 pieces per style per finish |
| Sampling | 12 working days, 3 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | GB 18401 safety classification with GB/T 29862 fibre labelling; CPSIA lead and phthalate testing |
| Ship to | Shanghai or Shenzhen (Mainland China) |
What buyers can customise
- Heat Transfer Printing — available on Cork, quoted per position and per colour.
- Rhinestone Setting — available on Cork, quoted per position and per colour.
- Epoxy Dome — available on Cork, quoted per position and per colour.
- Paint Spray — available on Cork, quoted per position and per colour.
- Pantone Colour Matching — available on Cork, quoted per position and per colour.
- Digital Printing — available on Cork, quoted per position and per colour.
- Debossing — available on Cork, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with sewn edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same plating thickness.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Which compliance documents do you provide?
We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 12 working days, and each revision about 3 days.
Start your badge programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
