Custom Rivet — Pewter with Heat Transfer Printing
We supply rivet to garment factories and brands, built in Pewter with heat transfer printing for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is setting pressure, which cracks caps if it is wrong in either direction, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Rivet |
|---|---|
| Cap diameter | 12 mm |
| Type | jeans rivet |
| Base material | Pewter |
| Finish / process | Heat Transfer Printing |
| Colour options | 8 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 2000 pieces per style per finish |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 25-50 days after approval |
| Compliance | SNI or SIRIM documentation per destination; CPSIA lead and phthalate testing |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Embossing — available on Pewter, quoted per position and per colour.
- Soft Enamel Fill — available on Pewter, quoted per position and per colour.
- UV Printing — available on Pewter, quoted per position and per colour.
- Rose Gold Plating — available on Pewter, quoted per position and per colour.
- Screen Printing — available on Pewter, quoted per position and per colour.
- Anti-Rust Treatment — available on Pewter, quoted per position and per colour.
- Epoxy Dome — available on Pewter, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed cap diameter
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with heat transfer printing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same setting pressure.
FAQ
Which compliance documents do you provide?
We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.
How long does sampling take?
A first sample takes 10 working days, and each revision about 3 days.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Start your rivet programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
