Custom Boning — Pewter with Soft Enamel Fill
We supply boning to garment factories and brands, built in Pewter with soft enamel fill for uniform and corporate programmes. On a trim like this the specification that decides the outcome is spring-back, because boning that takes a permanent bend is scrap, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Boning |
|---|---|
| Width | 12 mm |
| Type | flat polyester boning |
| Base material | Pewter |
| Finish / process | Soft Enamel Fill |
| Colour options | 24 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 5000 pieces per style per finish |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | REACH and GPSR documentation; azo dye-free declaration |
| Ship to | Rotterdam or Felixstowe (Europe) |
What buyers can customise
- Die-Casting — available on Pewter, quoted per position and per colour.
- Rubber Coating — available on Pewter, quoted per position and per colour.
- Braided Weave — available on Pewter, quoted per position and per colour.
- Crochet — available on Pewter, quoted per position and per colour.
- Mercerised Finish — available on Pewter, quoted per position and per colour.
- Heat-Cut Edge — available on Pewter, quoted per position and per colour.
- Epoxy Dome — available on Pewter, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed width
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with soft enamel fill applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for azo dye-free declaration are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same spring-back.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Which compliance documents do you provide?
We prepare azo dye-free declaration and the supporting test reports for the destination market.
How long does sampling take?
A first sample takes 14 working days, and each revision about 5 days.
What is the minimum order?
Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.
Start your boning programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
