Custom Sequin in Polypropylene (PP) with Debossing for Outerwear and Jacket Programmes

Custom Sequin — Polypropylene (PP) with Debossing

We supply sequin to garment factories and brands, built in Polypropylene (PP) with debossing for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is hole position, because off-centre holes skew the whole row, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Rhinestone Setting — available on Polypropylene (PP), quoted per position and per colour.
• Fringe Finish — available on Polypropylene (PP), quoted per position and per colour.
• Soft Enamel Fill — available on Polypropylene (PP), quoted per position and per colour.
• Powder Coating — available on Polypropylene (PP), quoted per position and per colour.
• Offset Printing — available on Polypropylene (PP), quoted per position and per colour.
• Sewn Edge — available on Polypropylene (PP), quoted per position and per colour.
• Laser Engraving — available on Polypropylene (PP), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed size
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with debossing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole position.

FAQ

What is the minimum order?

Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Which compliance documents do you provide?

We prepare REACH nickel-release test for metal findings and the supporting test reports for the destination market.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

Start your sequin programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.