Custom Sequin — Pewter with Ultrasonic Welding
We supply sequin to garment factories and brands, built in Pewter with ultrasonic welding for denim and workwear programmes. On a trim like this the specification that decides the outcome is hole position, because off-centre holes skew the whole row, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Sequin |
|---|---|
| Size | 3 mm |
| Finish | matte sequin |
| Base material | Pewter |
| Finish / process | Ultrasonic Welding |
| Colour options | 12 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 500 pieces per style per finish |
| Sampling | 12 working days, 3 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; EN 71 part 3 for decorative components |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Laser Engraving — available on Pewter, quoted per position and per colour.
- Digital Printing — available on Pewter, quoted per position and per colour.
- Debossing — available on Pewter, quoted per position and per colour.
- Offset Printing — available on Pewter, quoted per position and per colour.
- Powder Coating — available on Pewter, quoted per position and per colour.
- Sewn Edge — available on Pewter, quoted per position and per colour.
- Epoxy Dome — available on Pewter, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with ultrasonic welding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole position.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
What is the minimum order?
Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 12 working days, and each revision about 3 days.
Start your sequin programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
