Custom Buckle — Iron with Black Oxide
We supply buckle to garment factories and brands, built in Iron with black oxide for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is pull strength under load, tested before the tooling is signed off, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Buckle |
|---|---|
| Size | 25 mm |
| Type | single-bar buckle |
| Base material | Iron |
| Finish / process | Black Oxide |
| Colour options | 12 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 500 pieces per style per finish |
| Sampling | 7 working days, 4 days per revision |
| Bulk lead time | 25-30 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; colour fastness to washing, rubbing and light |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Hard Enamel Fill — available on Iron, quoted per position and per colour.
- Gunmetal Plating — available on Iron, quoted per position and per colour.
- Heat Transfer Printing — available on Iron, quoted per position and per colour.
- Brushed Finish — available on Iron, quoted per position and per colour.
- Powder Coating — available on Iron, quoted per position and per colour.
- Hot Foil Stamping — available on Iron, quoted per position and per colour.
- Rubber Coating — available on Iron, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with black oxide applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same pull strength under load.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Which compliance documents do you provide?
We prepare colour fastness to washing, rubbing and light and the supporting test reports for the destination market.
How long does sampling take?
A first sample takes 7 working days, and each revision about 4 days.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your buckle programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
