Custom Buckle — Brass with Brushed Finish
We supply buckle to garment factories and brands, built in Brass with brushed finish for denim and workwear programmes. On a trim like this the specification that decides the outcome is plating adhesion on the contact edges where the strap rubs, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: packing that arrives mixed and unusable on the line, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Buckle |
|---|---|
| Size | 38 mm |
| Type | roller buckle |
| Base material | Brass |
| Finish / process | Brushed Finish |
| Colour options | 6 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 1000 pieces per style per finish |
| Sampling | 14 working days, 5 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | REACH and GPSR documentation; EN 71 part 3 for decorative components |
| Ship to | Rotterdam or Felixstowe (Europe) |
What buyers can customise
- Digital Printing — available on Brass, quoted per position and per colour.
- Ultrasonic Welding — available on Brass, quoted per position and per colour.
- Brushed Finish — available on Brass, quoted per position and per colour.
- Offset Printing — available on Brass, quoted per position and per colour.
- Hot Foil Stamping — available on Brass, quoted per position and per colour.
- Heat Transfer Printing — available on Brass, quoted per position and per colour.
- Hard Enamel Fill — available on Brass, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with brushed finish applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same plating adhesion on the contact edges where the strap rubs.
FAQ
Which compliance documents do you provide?
We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.
How long does sampling take?
A first sample takes 14 working days, and each revision about 5 days.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Start your buckle programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
