Custom Apparel Bead in Polypropylene (PP) with Heat Transfer Printing for Denim and Workwear Programmes

Custom Apparel Bead — Polypropylene (PP) with Heat Transfer Printing

We supply apparel bead to garment factories and brands, built in Polypropylene (PP) with heat transfer printing for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is facet consistency, since uneven facets read as cheap on garment, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: a finish that tarnishes or rubs off after washing, or a supplier who disappears once the deposit is paid. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Dye-Sublimation Printing — available on Polypropylene (PP), quoted per position and per colour.
• Rubber Coating — available on Polypropylene (PP), quoted per position and per colour.
• Pantone Colour Matching — available on Polypropylene (PP), quoted per position and per colour.
• Hard Enamel Fill — available on Polypropylene (PP), quoted per position and per colour.
• Chrome Plating — available on Polypropylene (PP), quoted per position and per colour.
• Crochet — available on Polypropylene (PP), quoted per position and per colour.
• Heat-Cut Edge — available on Polypropylene (PP), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed size
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with heat transfer printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for OEKO-TEX Standard 100 for dyes and trims are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same facet consistency.

FAQ

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

How long does sampling take?

A first sample takes 12 working days, and each revision about 5 days.

Which compliance documents do you provide?

We prepare OEKO-TEX Standard 100 for dyes and trims and the supporting test reports for the destination market.

What is the minimum order?

Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.

Start your apparel bead programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.