Custom Lingerie Accessory — Elastic Rubber with Embroidery
We supply lingerie accessory to garment factories and brands, built in Elastic Rubber with embroidery for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is profile and edge smoothness, which show through fine fabric, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Lingerie Accessory |
|---|---|
| Size | 19 mm |
| Type | lingerie bow |
| Base material | Elastic Rubber |
| Finish / process | Embroidery |
| Colour options | 12 Pantone-matched shades |
| Packing | carded |
| MOQ | 2000 pieces per style per finish |
| Sampling | 12 working days, 4 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | SNI or SIRIM documentation per destination; CPSIA lead and phthalate testing |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Antique Silver — available on Elastic Rubber, quoted per position and per colour.
- Beaded Detail — available on Elastic Rubber, quoted per position and per colour.
- Stamping — available on Elastic Rubber, quoted per position and per colour.
- Crochet — available on Elastic Rubber, quoted per position and per colour.
- Sequin Stitching — available on Elastic Rubber, quoted per position and per colour.
- Fringe Finish — available on Elastic Rubber, quoted per position and per colour.
- Gunmetal Plating — available on Elastic Rubber, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with embroidery applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same profile and edge smoothness.
FAQ
Which compliance documents do you provide?
We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How long does sampling take?
A first sample takes 12 working days, and each revision about 4 days.
Start your lingerie accessory programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
