Custom Eyelet — Brass with Black Oxide
We supply eyelet to garment factories and brands, built in Brass with black oxide for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is washer bite, so the eyelet does not pull out of the cloth, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Eyelet |
|---|---|
| Inner diameter | 4 mm |
| Type | self-piercing eyelet |
| Base material | Brass |
| Finish / process | Black Oxide |
| Colour options | 12 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 500 pieces per style per finish |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; OEKO-TEX Standard 100 for dyes and trims |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Overlocked Edge — available on Brass, quoted per position and per colour.
- Hard Enamel Fill — available on Brass, quoted per position and per colour.
- Anti-Rust Treatment — available on Brass, quoted per position and per colour.
- Stamping — available on Brass, quoted per position and per colour.
- Powder Coating — available on Brass, quoted per position and per colour.
- Die-Casting — available on Brass, quoted per position and per colour.
- Antique Silver — available on Brass, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed inner diameter
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with black oxide applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for OEKO-TEX Standard 100 for dyes and trims are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same washer bite.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How long does sampling take?
A first sample takes 10 working days, and each revision about 3 days.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
What is the minimum order?
Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.
Start your eyelet programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
