Custom Eyelet — PVC with Injection Moulding
We supply eyelet to garment factories and brands, built in PVC with injection moulding for uniform and corporate programmes. On a trim like this the specification that decides the outcome is setting tooling tolerance, which decides whether the line runs clean, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: shade variation within one carton, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Eyelet |
|---|---|
| Inner diameter | 5 mm |
| Type | two-part eyelet and washer |
| Base material | PVC |
| Finish / process | Injection Moulding |
| Colour options | 24 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 1000 pieces per style per finish |
| Sampling | 12 working days, 3 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | SNI or SIRIM documentation per destination; azo dye-free declaration |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Paint Spray — available on PVC, quoted per position and per colour.
- Soft Enamel Fill — available on PVC, quoted per position and per colour.
- Anti-Rust Treatment — available on PVC, quoted per position and per colour.
- Hard Enamel Fill — available on PVC, quoted per position and per colour.
- Epoxy Dome — available on PVC, quoted per position and per colour.
- Powder Coating — available on PVC, quoted per position and per colour.
- Brushed Finish — available on PVC, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed inner diameter
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for azo dye-free declaration are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same setting tooling tolerance.
FAQ
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 12 working days, and each revision about 3 days.
Start your eyelet programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
