Custom Rhinestone — Iron with Gunmetal Plating
We supply rhinestone to garment factories and brands, built in Iron with gunmetal plating for denim and workwear programmes. On a trim like this the specification that decides the outcome is wash durability of the setting, measured in cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Rhinestone |
|---|---|
| Size | SS20 / 5 mm |
| Type | transfer sheet |
| Base material | Iron |
| Finish / process | Gunmetal Plating |
| Colour options | 12 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 500 pieces per style per finish |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | SNI or SIRIM documentation per destination; salt spray test for metal finishes |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Soft Enamel Fill — available on Iron, quoted per position and per colour.
- Overlocked Edge — available on Iron, quoted per position and per colour.
- Rhinestone Setting — available on Iron, quoted per position and per colour.
- Gold Plating — available on Iron, quoted per position and per colour.
- Hard Enamel Fill — available on Iron, quoted per position and per colour.
- Powder Coating — available on Iron, quoted per position and per colour.
- Sewn Edge — available on Iron, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with gunmetal plating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same wash durability of the setting.
FAQ
What is the minimum order?
Programmes start at 500 pieces per style per finish. Mixed sizes are fine within one style.
Which compliance documents do you provide?
We prepare salt spray test for metal finishes and the supporting test reports for the destination market.
How long does sampling take?
A first sample takes 10 working days, and each revision about 3 days.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Start your rhinestone programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
