Custom Rhinestone — Resin with Powder Coating
We supply rhinestone to garment factories and brands, built in Resin with powder coating for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is wash durability of the setting, measured in cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Rhinestone |
|---|---|
| Size | SS40 / 8 mm |
| Type | transfer sheet |
| Base material | Resin |
| Finish / process | Powder Coating |
| Colour options | 24 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 3000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; salt spray test for metal finishes |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Chrome Plating — available on Resin, quoted per position and per colour.
- Stamping — available on Resin, quoted per position and per colour.
- Mirror Polish — available on Resin, quoted per position and per colour.
- Overlocked Edge — available on Resin, quoted per position and per colour.
- Hard Enamel Fill — available on Resin, quoted per position and per colour.
- UV Printing — available on Resin, quoted per position and per colour.
- Soft Enamel Fill — available on Resin, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with powder coating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same wash durability of the setting.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
How long does sampling take?
A first sample takes 12 working days, and each revision about 5 days.
Start your rhinestone programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
