Custom Zipper in Polyethylene (PE) with Offset Printing for Uniform and Corporate Programmes

Custom Zipper — Polyethylene (PE) with Offset Printing

We supply zipper to garment factories and brands, built in Polyethylene (PE) with offset printing for uniform and corporate programmes. On a trim like this the specification that decides the outcome is pull strength of the slider and the stop, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: a supplier who disappears once the deposit is paid, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Woven Jacquard — available on Polyethylene (PE), quoted per position and per colour.
• Hot Foil Stamping — available on Polyethylene (PE), quoted per position and per colour.
• Overlocked Edge — available on Polyethylene (PE), quoted per position and per colour.
• Nickel Plating — available on Polyethylene (PE), quoted per position and per colour.
• Powder Coating — available on Polyethylene (PE), quoted per position and per colour.
• Paint Spray — available on Polyethylene (PE), quoted per position and per colour.
• Mercerised Finish — available on Polyethylene (PE), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed gauge
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with offset printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same pull strength of the slider and the stop.

FAQ

What is the minimum order?

Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Which compliance documents do you provide?

We prepare REACH nickel-release test for metal findings and the supporting test reports for the destination market.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Start your zipper programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.