Custom Zipper in Polycarbonate with Hot Foil Stamping for Denim and Workwear Programmes

Custom Zipper — Polycarbonate with Hot Foil Stamping

We supply zipper to garment factories and brands, built in Polycarbonate with hot foil stamping for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is slider smoothness across the full length, tested by hand on bulk, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Paint Spray — available on Polycarbonate, quoted per position and per colour.
• Chrome Plating — available on Polycarbonate, quoted per position and per colour.
• Offset Printing — available on Polycarbonate, quoted per position and per colour.
• Antique Silver — available on Polycarbonate, quoted per position and per colour.
• Brushed Finish — available on Polycarbonate, quoted per position and per colour.
• Rose Gold Plating — available on Polycarbonate, quoted per position and per colour.
• Nickel Plating — available on Polycarbonate, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed gauge
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with hot foil stamping applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same slider smoothness across the full length.

FAQ

Which compliance documents do you provide?

We prepare REACH nickel-release test for metal findings and the supporting test reports for the destination market.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

How long does sampling take?

A first sample takes 10 working days, and each revision about 3 days.

Start your zipper programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.