Custom Zipper in Nylon (PA) with Dye-Sublimation Printing for E-commerce and Small-Batch Brands

Custom Zipper — Nylon (PA) with Dye-Sublimation Printing

We supply zipper to garment factories and brands, built in Nylon (PA) with dye-sublimation printing for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is pull strength of the slider and the stop, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Antique Brass Plating — available on Nylon (PA), quoted per position and per colour.
• Offset Printing — available on Nylon (PA), quoted per position and per colour.
• Screen Printing — available on Nylon (PA), quoted per position and per colour.
• Hard Enamel Fill — available on Nylon (PA), quoted per position and per colour.
• Hot Foil Stamping — available on Nylon (PA), quoted per position and per colour.
• Crochet — available on Nylon (PA), quoted per position and per colour.
• Embossing — available on Nylon (PA), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed gauge
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with dye-sublimation printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same pull strength of the slider and the stop.

FAQ

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

Which compliance documents do you provide?

We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.

What packing options are available?

Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.

Start your zipper programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.