Custom Zipper — ABS Plastic with Powder Coating
We supply zipper to garment factories and brands, built in ABS Plastic with powder coating for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is slider smoothness across the full length, tested by hand on bulk, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Zipper |
|---|---|
| Gauge | #5 |
| Type | closed-end zipper |
| Base material | ABS Plastic |
| Finish / process | Powder Coating |
| Colour options | 16 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 2000 pieces per style per finish |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; azo dye-free declaration |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Offset Printing — available on ABS Plastic, quoted per position and per colour.
- Sewn Edge — available on ABS Plastic, quoted per position and per colour.
- Brushed Finish — available on ABS Plastic, quoted per position and per colour.
- Heat-Cut Edge — available on ABS Plastic, quoted per position and per colour.
- Mirror Polish — available on ABS Plastic, quoted per position and per colour.
- Pleating — available on ABS Plastic, quoted per position and per colour.
- Debossing — available on ABS Plastic, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed gauge
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with powder coating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for azo dye-free declaration are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same slider smoothness across the full length.
FAQ
How long does sampling take?
A first sample takes 14 working days, and each revision about 3 days.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your zipper programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
