Custom Hook and Eye — Nylon (PA) with Injection Moulding
We supply hook and eye to garment factories and brands, built in Nylon (PA) with injection moulding for uniform and corporate programmes. On a trim like this the specification that decides the outcome is profile height, which decides whether it prints through the cloth, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Hook and Eye |
|---|---|
| Size | No. 5 |
| Type | skirt hook |
| Base material | Nylon (PA) |
| Finish / process | Injection Moulding |
| Colour options | 6 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 2000 pieces per style per finish |
| Sampling | 14 working days, 3 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; colour fastness to washing, rubbing and light |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Epoxy Dome — available on Nylon (PA), quoted per position and per colour.
- Overlocked Edge — available on Nylon (PA), quoted per position and per colour.
- Gold Plating — available on Nylon (PA), quoted per position and per colour.
- Rubber Coating — available on Nylon (PA), quoted per position and per colour.
- Antique Brass Plating — available on Nylon (PA), quoted per position and per colour.
- Rose Gold Plating — available on Nylon (PA), quoted per position and per colour.
- Ultrasonic Welding — available on Nylon (PA), quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same profile height.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
How long does sampling take?
A first sample takes 14 working days, and each revision about 3 days.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Start your hook and eye programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
