Custom Zipper in Polyethylene (PE) with Hard Enamel Fill for Uniform and Corporate Programmes

Custom Zipper — Polyethylene (PE) with Hard Enamel Fill

We supply zipper to garment factories and brands, built in Polyethylene (PE) with hard enamel fill for denim and workwear programmes. On a trim like this the specification that decides the outcome is tape shrinkage matched to the garment fabric, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.

The failures here are predictable: inconsistent sizing between production runs, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Braided Weave — available on Polyethylene (PE), quoted per position and per colour.
• Die-Casting — available on Polyethylene (PE), quoted per position and per colour.
• Crochet — available on Polyethylene (PE), quoted per position and per colour.
• Hot Foil Stamping — available on Polyethylene (PE), quoted per position and per colour.
• Antique Brass Plating — available on Polyethylene (PE), quoted per position and per colour.
• Brushed Finish — available on Polyethylene (PE), quoted per position and per colour.
• Anti-Rust Treatment — available on Polyethylene (PE), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed gauge
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with hard enamel fill applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for REACH nickel-release test for metal findings are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same tape shrinkage matched to the garment fabric.

FAQ

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

How long does sampling take?

A first sample takes 7 working days, and each revision about 5 days.

Start your zipper programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.