Case Study: Custom Faux Leather Fabric for a Hat and Cap Producer in Saudi Arabia

Faux Leather Fabric for a Hat and Cap Producer in Saudi Arabia

A Hat and Cap Producer approached us with a faux leather fabric requirement for the Saudi Arabia market. The brief was specific: a defined look, a hard launch date and a unit cost that had to survive freight and duty. This case study records what was specified, what went wrong in sampling and how the bulk order was delivered.

The challenge

• A spec that lived in an email instead of a tech pack
• An interlining that bubbled after the first press
• A compliance document that arrived after the goods were already shipped

What we specified

How it was resolved

1. We rebuilt the specification around PU Leather and locked the tolerance before bulk.
2. The finish was moved to Glossy Enamel Coating after strike-off tests showed better durability.
3. A pre-production sample was approved and retained as the golden reference.
4. Production ran with in-line inspection and a mid-run photo report.
5. Cartons were packed to the client's own barcode and ratio specification.

Result

• 100,000 pieces delivered inside the 8-week window.
• Unit cost held within 2.0% of the original quotation.
• Inspection-related rejection stayed under 2.0%.
• The specification is now on file, so reorders reproduce the approved sample.

What we would repeat

Fix the specification count early. Adding variants after production starts is the most expensive change a client can request.

Planning something similar?

If you are comparing suppliers, send us the spec they quoted against. We will quote the same spec and show you where the difference sits.