Case Study: Custom Crochet Lace for a Workwear Distributor in Japan
Source:Gold Cartilage Earrings /
Time:2026-09-18
Crochet Lace for a Workwear Distributor in Japan
A Workwear Distributor approached us with a crochet lace requirement for the Japan market. The brief was specific: a defined look, a hard launch date and a unit cost that had to survive freight and duty. This case study records what was specified, what went wrong in sampling and how the bulk order was delivered.
The challenge
- A compliance document that arrived after the goods were already shipped
- A trim that passed sampling but failed in-line because it was never cycle tested
- A spec that lived in an email instead of a tech pack
What we specified
| Item | Crochet Lace |
|---|---|
| Client type | A Workwear Distributor |
| Market | Japan |
| Order volume | 50,000 pieces across 6 specifications |
| Base material | Polyester |
| Standard size | 6 mm Width |
| Finish | Laser Engraved Finish |
| Sampling rounds | 3 |
| Delivery window | 10 weeks from PO to ex-factory |
| Compliance | ISO 12947 Abrasion Resistance |
How it was resolved
- We rebuilt the specification around Polyester and locked the tolerance before bulk.
- The finish was moved to Yarn-Dyed Finish after strike-off tests showed better durability.
- A pre-production sample was approved and retained as the golden reference.
- Production ran with in-line inspection and a mid-run photo report.
- Cartons were packed to the client's own barcode and ratio specification.
Result
- 50,000 pieces delivered inside the 10-week window.
- Unit cost held within 4.5% of the original quotation.
- Inspection-related rejection stayed under 1.0%.
- The specification is now on file, so reorders reproduce the approved sample.
What we would repeat
Keep one accountable owner on both sides. Most delays come from hand-offs, not from machines.
Planning something similar?
If you are comparing suppliers, send us the spec they quoted against. We will quote the same spec and show you where the difference sits.
