Case Study: Custom Oxford Fabric for a School Uniform Buyer in Australia

Oxford Fabric for a School Uniform Buyer in Australia

A School Uniform Buyer approached us with a oxford fabric requirement for the Australia market. The brief was specific: a defined look, a hard launch date and a unit cost that had to survive freight and duty. This case study records what was specified, what went wrong in sampling and how the bulk order was delivered.

The challenge

• Shade drift between the approved lab dip and the bulk lot
• A trim that passed sampling but failed in-line because it was never cycle tested
• MOQ that was quoted per colourway rather than per style

What we specified

How it was resolved

1. We rebuilt the specification around Nickel Silver and locked the tolerance before bulk.
2. The finish was moved to Matte Black Coating after strike-off tests showed better durability.
3. A pre-production sample was approved and retained as the golden reference.
4. Production ran with in-line inspection and a mid-run photo report.
5. Cartons were packed to the client's own barcode and ratio specification.

Result

• 10,000 pieces delivered inside the 6-week window.
• Unit cost held within 2.0% of the original quotation.
• Inspection-related rejection stayed under 1.5%.
• The specification is now on file, so reorders reproduce the approved sample.

What we would repeat

Approve a pre-production sample made from the actual bulk base material. Substitute material behaves differently in finishing.

Planning something similar?

If you are comparing suppliers, send us the spec they quoted against. We will quote the same spec and show you where the difference sits.