Nylon Boning Tape for Kidswear — Specification, Uses and Sourcing Notes
Nylon Boning Tape for Kidswear: Specification, Uses and Sourcing Notes
Nylon Boning Tape is the version buyers specify for kidswear when the base material is fixed by performance rather than by price. This entry sets out what the material actually changes, which specification to write into the tech pack, and where the cost sits — the three questions that decide whether the item passes bulk approval.
What it is
Nylon gives boning tape its strength and surface character. In practice that means the trim behaves differently in cutting, in finishing and in wear: shrinkage allowance has to be built into the spec. Buyers who specify the material up front avoid the most common failure — an item that looks right on the sample card and behaves differently in bulk.
Typical specification
| Item | Boning Tape |
|---|---|
| Base material | Nylon |
| Standard size | 12 mm Width |
| Common finishes | Soft-Touch Rubber Coating, Anodised Finish, Antique Copper Finish |
| Processes | Weft Knitting, Moisture Wicking Finishing, Heat Setting |
| Typical application | Kidswear |
| Related applications | Down Jackets, Shirts, Boots, Sleepwear |
| Test standard | GRS |
| Usual packing | 500 pieces per polybag, 10000 per carton |
Properties that matter in buying
- Dimensional stability — 1% allowance is built into the spec before cutting.
- Colour fastness — tested to GRS on the actual base material, not on a substitute.
- Mechanical performance — elastic recovery after 30 cycles or washes.
- Compliance — GRS documentation issued with the shipment.
- Consistency — the approved counter sample becomes the reference for every reorder.
Common uses
- Outdoor Tents
- Activewear
- Caps
- Down Jackets
- Trousers
- Skirts
How to specify it
- Name the base material in the tech pack, not just the item.
- Fix the size and tolerance in writing before sampling starts.
- Approve a counter sample made from the actual bulk base material.
- Order the test report against the standard your market requires.
- Retain a golden sample at the factory and a second one with you.
Related reading
Related specifications on this site cover sequin trim, care label, grommet, bra strap, and the processes most often paired with boning tape include die casting, laser cutting, injection moulding.
Share the programme details and we will propose two alternatives — one optimised for unit cost, one for lead time — and let you choose.
