Custom Badge in Coconut Shell with Laser Engraving for Childrenswear and Schoolwear

Custom Badge — Coconut Shell with Laser Engraving

We supply badge to garment factories and brands, built in Coconut Shell with laser engraving for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is edge definition, because soft enamel lines blur below 1 mm, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: colour drift between the approved sample and the bulk trim, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Die-Casting — available on Coconut Shell, quoted per position and per colour.
• UV Printing — available on Coconut Shell, quoted per position and per colour.
• Debossing — available on Coconut Shell, quoted per position and per colour.
• Antique Silver — available on Coconut Shell, quoted per position and per colour.
• Embossing — available on Coconut Shell, quoted per position and per colour.
• Beaded Detail — available on Coconut Shell, quoted per position and per colour.
• Laser Engraving — available on Coconut Shell, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed attachment
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with laser engraving applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge definition.

FAQ

How long does sampling take?

A first sample takes 14 working days, and each revision about 3 days.

What is the minimum order?

Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Which compliance documents do you provide?

We prepare EN 71 part 3 for decorative components and the supporting test reports for the destination market.

Start your badge programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.