Custom Badge — Polypropylene (PP) with Epoxy Dome
We supply badge to garment factories and brands, built in Polypropylene (PP) with epoxy dome for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is edge definition, because soft enamel lines blur below 1 mm, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: packing that arrives mixed and unusable on the line, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | safety pin |
| Size | 30 mm |
| Base material | Polypropylene (PP) |
| Finish / process | Epoxy Dome |
| Colour options | 16 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 2000 pieces per style per finish |
| Sampling | 12 working days, 3 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; colour fastness to washing, rubbing and light |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Paint Spray — available on Polypropylene (PP), quoted per position and per colour.
- Digital Printing — available on Polypropylene (PP), quoted per position and per colour.
- Hot Foil Stamping — available on Polypropylene (PP), quoted per position and per colour.
- Stamping — available on Polypropylene (PP), quoted per position and per colour.
- Antique Silver — available on Polypropylene (PP), quoted per position and per colour.
- Powder Coating — available on Polypropylene (PP), quoted per position and per colour.
- Rhinestone Setting — available on Polypropylene (PP), quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with epoxy dome applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge definition.
FAQ
How long does sampling take?
A first sample takes 12 working days, and each revision about 3 days.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Start your badge programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
