Custom Badge — Neoprene with Injection Moulding
We supply badge to garment factories and brands, built in Neoprene with injection moulding for uniform and corporate programmes. On a trim like this the specification that decides the outcome is edge definition, because soft enamel lines blur below 1 mm, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: a finish that tarnishes or rubs off after washing, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | magnetic backing |
| Size | 30 mm |
| Base material | Neoprene |
| Finish / process | Injection Moulding |
| Colour options | 12 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 1000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; salt spray test for metal finishes |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Mirror Polish — available on Neoprene, quoted per position and per colour.
- Brushed Finish — available on Neoprene, quoted per position and per colour.
- Sewn Edge — available on Neoprene, quoted per position and per colour.
- Sequin Stitching — available on Neoprene, quoted per position and per colour.
- Gunmetal Plating — available on Neoprene, quoted per position and per colour.
- Tassel Finish — available on Neoprene, quoted per position and per colour.
- Dye-Sublimation Printing — available on Neoprene, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge definition.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How long does sampling take?
A first sample takes 12 working days, and each revision about 5 days.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Which compliance documents do you provide?
We prepare salt spray test for metal finishes and the supporting test reports for the destination market.
Start your badge programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
