Custom Badge — Bone with Tassel Finish
We supply badge to garment factories and brands, built in Bone with tassel finish for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is edge definition, because soft enamel lines blur below 1 mm, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | sew-on holes |
| Size | 38 mm |
| Base material | Bone |
| Finish / process | Tassel Finish |
| Colour options | 6 Pantone-matched shades |
| Packing | carded |
| MOQ | 500 pieces per style per finish |
| Sampling | 10 working days, 3 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | REACH and GPSR documentation; CPSIA lead and phthalate testing |
| Ship to | Rotterdam or Felixstowe (Europe) |
What buyers can customise
- Epoxy Dome — available on Bone, quoted per position and per colour.
- Chrome Plating — available on Bone, quoted per position and per colour.
- Sewn Edge — available on Bone, quoted per position and per colour.
- Gunmetal Plating — available on Bone, quoted per position and per colour.
- Paint Spray — available on Bone, quoted per position and per colour.
- Black Oxide — available on Bone, quoted per position and per colour.
- Nickel Plating — available on Bone, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with tassel finish applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge definition.
FAQ
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
How long does sampling take?
A first sample takes 10 working days, and each revision about 3 days.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your badge programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
