Custom Badge — Cotton with Sewn Edge
We supply badge to garment factories and brands, built in Cotton with sewn edge for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is plating thickness, which decides how long the badge survives wear, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare CPSIA and California Prop 65 compliance so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | butterfly clutch |
| Size | 50 mm |
| Base material | Cotton |
| Finish / process | Sewn Edge |
| Colour options | 24 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 1000 pieces per style per finish |
| Sampling | 7 working days, 3 days per revision |
| Bulk lead time | 20-50 days after approval |
| Compliance | CPSIA and California Prop 65 compliance; salt spray test for metal finishes |
| Ship to | Los Angeles or New York (North America) |
What buyers can customise
- Debossing — available on Cotton, quoted per position and per colour.
- Pantone Colour Matching — available on Cotton, quoted per position and per colour.
- Antique Silver — available on Cotton, quoted per position and per colour.
- Ultrasonic Welding — available on Cotton, quoted per position and per colour.
- Gunmetal Plating — available on Cotton, quoted per position and per colour.
- Embossing — available on Cotton, quoted per position and per colour.
- Epoxy Dome — available on Cotton, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with sewn edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Los Angeles or New York with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same plating thickness.
FAQ
How long does sampling take?
A first sample takes 7 working days, and each revision about 3 days.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
Which compliance documents do you provide?
We prepare salt spray test for metal finishes and the supporting test reports for the destination market.
Start your badge programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
