Custom Badge — Copper with Debossing
We supply badge to garment factories and brands, built in Copper with debossing for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is edge definition, because soft enamel lines blur below 1 mm, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: a finish that tarnishes or rubs off after washing, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Badge |
|---|---|
| Attachment | sew-on holes |
| Size | 20 mm |
| Base material | Copper |
| Finish / process | Debossing |
| Colour options | 12 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 5000 pieces per style per finish |
| Sampling | 7 working days, 4 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | REACH and GPSR documentation; salt spray test for metal finishes |
| Ship to | Rotterdam or Felixstowe (Europe) |
What buyers can customise
- Screen Printing — available on Copper, quoted per position and per colour.
- Offset Printing — available on Copper, quoted per position and per colour.
- Epoxy Dome — available on Copper, quoted per position and per colour.
- Laser Engraving — available on Copper, quoted per position and per colour.
- UV Printing — available on Copper, quoted per position and per colour.
- Soft Enamel Fill — available on Copper, quoted per position and per colour.
- Gunmetal Plating — available on Copper, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed attachment
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with debossing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge definition.
FAQ
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How long does sampling take?
A first sample takes 7 working days, and each revision about 4 days.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Start your badge programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
