Custom Sequin in Stainless Steel with Sewn Edge for Uniform and Corporate Programmes

Custom Sequin — Stainless Steel with Sewn Edge

We supply sequin to garment factories and brands, built in Stainless Steel with sewn edge for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is hole position, because off-centre holes skew the whole row, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.

The failures here are predictable: a finish that tarnishes or rubs off after washing, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare REACH and GPSR documentation so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• UV Printing — available on Stainless Steel, quoted per position and per colour.
• Digital Printing — available on Stainless Steel, quoted per position and per colour.
• Overlocked Edge — available on Stainless Steel, quoted per position and per colour.
• Dye-Sublimation Printing — available on Stainless Steel, quoted per position and per colour.
• Rhinestone Setting — available on Stainless Steel, quoted per position and per colour.
• Ultrasonic Welding — available on Stainless Steel, quoted per position and per colour.
• Offset Printing — available on Stainless Steel, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed size
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with sewn edge applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Rotterdam or Felixstowe with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hole position.

FAQ

How long does sampling take?

A first sample takes 12 working days, and each revision about 5 days.

What is the minimum order?

Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Can you do small runs across many designs?

Yes — many studio and boutique programmes run small quantities across a wide design set.

Start your sequin programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.