Custom Boning — Organza with Stamping
We supply boning to garment factories and brands, built in Organza with stamping for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is tip finishing, which decides whether it wears through the casing, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Boning |
|---|---|
| Width | 5 mm |
| Type | casing-covered boning |
| Base material | Organza |
| Finish / process | Stamping |
| Colour options | 16 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 1000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | SNI or SIRIM documentation per destination; GRS recycled content claim |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Braided Weave — available on Organza, quoted per position and per colour.
- Sewn Edge — available on Organza, quoted per position and per colour.
- Rubber Coating — available on Organza, quoted per position and per colour.
- Crochet — available on Organza, quoted per position and per colour.
- Yarn Dyeing — available on Organza, quoted per position and per colour.
- Heat-Cut Edge — available on Organza, quoted per position and per colour.
- Woven Jacquard — available on Organza, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed width
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with stamping applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same tip finishing.
FAQ
Which compliance documents do you provide?
We prepare GRS recycled content claim and the supporting test reports for the destination market.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
How long does sampling take?
A first sample takes 12 working days, and each revision about 5 days.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Start your boning programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
