Custom Hook and Loop Tape — Polyester with Injection Moulding
We supply hook and loop tape to garment factories and brands, built in Polyester with injection moulding for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is hook wear on the loop side, which is what fails first, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Hook and Loop Tape |
|---|---|
| Width | 38 mm |
| Type | iron-on tape |
| Base material | Polyester |
| Finish / process | Injection Moulding |
| Colour options | 12 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 2000 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; OEKO-TEX Standard 100 for dyes and trims |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Sewn Edge — available on Polyester, quoted per position and per colour.
- Epoxy Dome — available on Polyester, quoted per position and per colour.
- UV Printing — available on Polyester, quoted per position and per colour.
- Embroidery — available on Polyester, quoted per position and per colour.
- Piece Dyeing — available on Polyester, quoted per position and per colour.
- Yarn Dyeing — available on Polyester, quoted per position and per colour.
- Hard Enamel Fill — available on Polyester, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed width
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for OEKO-TEX Standard 100 for dyes and trims are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same hook wear on the loop side.
FAQ
How long does sampling take?
A first sample takes 10 working days, and each revision about 4 days.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Which compliance documents do you provide?
We prepare OEKO-TEX Standard 100 for dyes and trims and the supporting test reports for the destination market.
Start your hook and loop tape programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
