Custom Buckle — Pewter with Heat Transfer Printing
We supply buckle to garment factories and brands, built in Pewter with heat transfer printing for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is gate tolerance, so the strap feeds without slipping, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Buckle |
|---|---|
| Size | 20 mm |
| Type | side-release buckle |
| Base material | Pewter |
| Finish / process | Heat Transfer Printing |
| Colour options | 24 Pantone-matched shades |
| Packing | carded |
| MOQ | 2000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 25-50 days after approval |
| Compliance | GSO conformity with Arabic labelling; colour fastness to washing, rubbing and light |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Embossing — available on Pewter, quoted per position and per colour.
- Hard Enamel Fill — available on Pewter, quoted per position and per colour.
- Rubber Coating — available on Pewter, quoted per position and per colour.
- Sewn Edge — available on Pewter, quoted per position and per colour.
- UV Printing — available on Pewter, quoted per position and per colour.
- Black Oxide — available on Pewter, quoted per position and per colour.
- Epoxy Dome — available on Pewter, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with heat transfer printing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same gate tolerance.
FAQ
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Which compliance documents do you provide?
We prepare colour fastness to washing, rubbing and light and the supporting test reports for the destination market.
Start your buckle programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
