Custom Shoulder Pad — Polyethylene (PE) with Paint Spray
We supply shoulder pad to garment factories and brands, built in Polyethylene (PE) with paint spray for denim and workwear programmes. On a trim like this the specification that decides the outcome is wash stability of the foam, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 500 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Shoulder Pad |
|---|---|
| Thickness | 25 mm |
| Type | sleeve head pad |
| Base material | Polyethylene (PE) |
| Finish / process | Paint Spray |
| Colour options | 12 Pantone-matched shades |
| Packing | packed to your size ratio |
| MOQ | 500 pieces per style per finish |
| Sampling | 7 working days, 4 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | SNI or SIRIM documentation per destination; colour fastness to washing, rubbing and light |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Piece Dyeing — available on Polyethylene (PE), quoted per position and per colour.
- Anti-Rust Treatment — available on Polyethylene (PE), quoted per position and per colour.
- Paint Spray — available on Polyethylene (PE), quoted per position and per colour.
- Heat-Cut Edge — available on Polyethylene (PE), quoted per position and per colour.
- Yarn Dyeing — available on Polyethylene (PE), quoted per position and per colour.
- Overlocked Edge — available on Polyethylene (PE), quoted per position and per colour.
- Stamping — available on Polyethylene (PE), quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed thickness
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with paint spray applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for colour fastness to washing, rubbing and light are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same wash stability of the foam.
FAQ
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How long does sampling take?
A first sample takes 7 working days, and each revision about 4 days.
Do you ship to our forwarder?
Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.
Start your shoulder pad programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
