Custom Buckle — ABS Plastic with Embossing
We supply buckle to garment factories and brands, built in ABS Plastic with embossing for uniform and corporate programmes. On a trim like this the specification that decides the outcome is pull strength under load, tested before the tooling is signed off, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: shade variation within one carton, or a finish that tarnishes or rubs off after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Buckle |
|---|---|
| Size | 25 mm |
| Type | side-release buckle |
| Base material | ABS Plastic |
| Finish / process | Embossing |
| Colour options | 12 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 5000 pieces per style per finish |
| Sampling | 12 working days, 4 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | GSO conformity with Arabic labelling; CPSIA lead and phthalate testing |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Mirror Polish — available on ABS Plastic, quoted per position and per colour.
- Black Oxide — available on ABS Plastic, quoted per position and per colour.
- Rubber Coating — available on ABS Plastic, quoted per position and per colour.
- Rose Gold Plating — available on ABS Plastic, quoted per position and per colour.
- Laser Engraving — available on ABS Plastic, quoted per position and per colour.
- Hot Foil Stamping — available on ABS Plastic, quoted per position and per colour.
- Antique Silver — available on ABS Plastic, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with embossing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same pull strength under load.
FAQ
How long does sampling take?
A first sample takes 12 working days, and each revision about 4 days.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Start your buckle programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
