Custom Cord Stopper in Nickel-Free Alloy with Digital Printing for E-commerce and Small-Batch Brands

Custom Cord Stopper — Nickel-Free Alloy with Digital Printing

We supply cord stopper to garment factories and brands, built in Nickel-Free Alloy with digital printing for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is spring life across repeated release cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: unclear responsibility when a defect shows up after washing, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Debossing — available on Nickel-Free Alloy, quoted per position and per colour.
• Gunmetal Plating — available on Nickel-Free Alloy, quoted per position and per colour.
• Nickel Plating — available on Nickel-Free Alloy, quoted per position and per colour.
• Overlocked Edge — available on Nickel-Free Alloy, quoted per position and per colour.
• Stamping — available on Nickel-Free Alloy, quoted per position and per colour.
• Dye-Sublimation Printing — available on Nickel-Free Alloy, quoted per position and per colour.
• Epoxy Dome — available on Nickel-Free Alloy, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed bore
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with digital printing applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same spring life across repeated release cycles.

FAQ

Which compliance documents do you provide?

We prepare GRS recycled content claim and the supporting test reports for the destination market.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

How long does sampling take?

A first sample takes 12 working days, and each revision about 4 days.

What is the minimum order?

Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.

Start your cord stopper programme

Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.