Custom Garment Accessory — Brass with Rubber Coating
We supply garment accessory to garment factories and brands, built in Brass with rubber coating for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is what the line actually needs at the workstation, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Garment Accessory |
|---|---|
| Packing | boxed sets |
| Type | garment accessory set |
| Base material | Brass |
| Finish / process | Rubber Coating |
| Colour options | 8 Pantone-matched shades |
| Packing | polybag per 100 |
| MOQ | 5000 pieces per style per finish |
| Sampling | 12 working days, 4 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | GSO conformity with Arabic labelling; salt spray test for metal finishes |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Epoxy Dome — available on Brass, quoted per position and per colour.
- Tassel Finish — available on Brass, quoted per position and per colour.
- Hard Enamel Fill — available on Brass, quoted per position and per colour.
- Digital Printing — available on Brass, quoted per position and per colour.
- Offset Printing — available on Brass, quoted per position and per colour.
- Heat Transfer Printing — available on Brass, quoted per position and per colour.
- Die-Casting — available on Brass, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed packing
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with rubber coating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same what the line actually needs at the workstation.
FAQ
What is the minimum order?
Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.
Which compliance documents do you provide?
We prepare salt spray test for metal finishes and the supporting test reports for the destination market.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your garment accessory programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
