Custom Lingerie Accessory — Polycarbonate with Pleating
We supply lingerie accessory to garment factories and brands, built in Polycarbonate with pleating for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is skin contact comfort, since these sit against the body all day, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Lingerie Accessory |
|---|---|
| Size | 8 mm |
| Type | ring and slider set |
| Base material | Polycarbonate |
| Finish / process | Pleating |
| Colour options | 6 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 1000 pieces per style per finish |
| Sampling | 7 working days, 4 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | GSO conformity with Arabic labelling; salt spray test for metal finishes |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Brushed Finish — available on Polycarbonate, quoted per position and per colour.
- Gunmetal Plating — available on Polycarbonate, quoted per position and per colour.
- Piece Dyeing — available on Polycarbonate, quoted per position and per colour.
- Black Oxide — available on Polycarbonate, quoted per position and per colour.
- Ultrasonic Welding — available on Polycarbonate, quoted per position and per colour.
- Antique Brass Plating — available on Polycarbonate, quoted per position and per colour.
- Sewn Edge — available on Polycarbonate, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with pleating applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for salt spray test for metal finishes are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same skin contact comfort.
FAQ
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 7 working days, and each revision about 4 days.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Start your lingerie accessory programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
