Custom Lingerie Accessory — Iron with Fringe Finish
We supply lingerie accessory to garment factories and brands, built in Iron with fringe finish for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is plating that survives perspiration and repeated washing, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or packing that arrives mixed and unusable on the line. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Lingerie Accessory |
|---|---|
| Size | 12 mm |
| Type | underwire channel |
| Base material | Iron |
| Finish / process | Fringe Finish |
| Colour options | 12 Pantone-matched shades |
| Packing | carded |
| MOQ | 2000 pieces per style per finish |
| Sampling | 12 working days, 4 days per revision |
| Bulk lead time | 20-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; GRS recycled content claim |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Overlocked Edge — available on Iron, quoted per position and per colour.
- Antique Brass Plating — available on Iron, quoted per position and per colour.
- Nickel Plating — available on Iron, quoted per position and per colour.
- Pantone Colour Matching — available on Iron, quoted per position and per colour.
- Stamping — available on Iron, quoted per position and per colour.
- Crochet — available on Iron, quoted per position and per colour.
- Heat-Cut Edge — available on Iron, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with fringe finish applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same plating that survives perspiration and repeated washing.
FAQ
Which compliance documents do you provide?
We prepare GRS recycled content claim and the supporting test reports for the destination market.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
How long does sampling take?
A first sample takes 12 working days, and each revision about 4 days.
What is the minimum order?
Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.
Start your lingerie accessory programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
