Custom Lingerie Accessory — Natural Rubber with Heat-Cut Edge
We supply lingerie accessory to garment factories and brands, built in Natural Rubber with heat-cut edge for bridal and eveningwear studios. On a trim like this the specification that decides the outcome is plating that survives perspiration and repeated washing, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: minimum order quantities far above what a growing brand can absorb, or colour drift between the approved sample and the bulk trim. We lock material, finish, dimension and tolerance before bulk, and prepare SNI or SIRIM documentation per destination so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Lingerie Accessory |
|---|---|
| Size | 8 mm |
| Type | lingerie bow |
| Base material | Natural Rubber |
| Finish / process | Heat-Cut Edge |
| Colour options | 16 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 1000 pieces per style per finish |
| Sampling | 12 working days, 5 days per revision |
| Bulk lead time | 15-40 days after approval |
| Compliance | SNI or SIRIM documentation per destination; GRS recycled content claim |
| Ship to | Jakarta or Port Klang (Asia-Pacific) |
What buyers can customise
- Overlocked Edge — available on Natural Rubber, quoted per position and per colour.
- Stamping — available on Natural Rubber, quoted per position and per colour.
- Black Oxide — available on Natural Rubber, quoted per position and per colour.
- Woven Jacquard — available on Natural Rubber, quoted per position and per colour.
- Injection Moulding — available on Natural Rubber, quoted per position and per colour.
- Pleating — available on Natural Rubber, quoted per position and per colour.
- Yarn Dyeing — available on Natural Rubber, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with heat-cut edge applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for GRS recycled content claim are prepared for the destination market. We ship to Jakarta or Port Klang with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same plating that survives perspiration and repeated washing.
FAQ
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
How long does sampling take?
A first sample takes 12 working days, and each revision about 5 days.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
Start your lingerie accessory programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
