Custom Rhinestone — Glass with Injection Moulding
We supply rhinestone to garment factories and brands, built in Glass with injection moulding for outerwear and jacket programmes. On a trim like this the specification that decides the outcome is wash durability of the setting, measured in cycles, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.
The failures here are predictable: inconsistent sizing between production runs, or shade variation within one carton. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Rhinestone |
|---|---|
| Size | SS16 / 4 mm |
| Type | rim-set stone |
| Base material | Glass |
| Finish / process | Injection Moulding |
| Colour options | 16 Pantone-matched shades |
| Packing | bulk packed |
| MOQ | 3000 pieces per style per finish |
| Sampling | 7 working days, 4 days per revision |
| Bulk lead time | 20-40 days after approval |
| Compliance | GSO conformity with Arabic labelling; EN 71 part 3 for decorative components |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Black Oxide — available on Glass, quoted per position and per colour.
- Fringe Finish — available on Glass, quoted per position and per colour.
- Epoxy Dome — available on Glass, quoted per position and per colour.
- Brushed Finish — available on Glass, quoted per position and per colour.
- Anti-Rust Treatment — available on Glass, quoted per position and per colour.
- Sewn Edge — available on Glass, quoted per position and per colour.
- Paint Spray — available on Glass, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed size
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same wash durability of the setting.
FAQ
What is the minimum order?
Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
How long does sampling take?
A first sample takes 7 working days, and each revision about 4 days.
How do you control colour on reorders?
The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.
Start your rhinestone programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
