Custom Rhinestone in Polyethylene (PE) with Overlocked Edge for Uniform and Corporate Programmes

Custom Rhinestone — Polyethylene (PE) with Overlocked Edge

We supply rhinestone to garment factories and brands, built in Polyethylene (PE) with overlocked edge for uniform and corporate programmes. On a trim like this the specification that decides the outcome is glue activation window on a hot-fix stone, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 2000 pieces per style per finish.

The failures here are predictable: colour drift between the approved sample and the bulk trim, or inconsistent sizing between production runs. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Rhinestone Setting — available on Polyethylene (PE), quoted per position and per colour.
• Paint Spray — available on Polyethylene (PE), quoted per position and per colour.
• Overlocked Edge — available on Polyethylene (PE), quoted per position and per colour.
• Hard Enamel Fill — available on Polyethylene (PE), quoted per position and per colour.
• Epoxy Dome — available on Polyethylene (PE), quoted per position and per colour.
• Rose Gold Plating — available on Polyethylene (PE), quoted per position and per colour.
• Mirror Polish — available on Polyethylene (PE), quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed size
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with overlocked edge applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same glue activation window on a hot-fix stone.

FAQ

How long does sampling take?

A first sample takes 7 working days, and each revision about 4 days.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

What is the minimum order?

Programmes start at 2000 pieces per style per finish. Mixed sizes are fine within one style.

Do you ship to our forwarder?

Yes. We deliver to your nominated forwarder or quote landed cost under the agreed Incoterm.

Start your rhinestone programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.