Custom Webbing — Viscose with Heat Transfer Printing
We supply webbing to garment factories and brands, built in Viscose with heat transfer printing for childrenswear and schoolwear. On a trim like this the specification that decides the outcome is edge stiffness, which decides how it feeds through hardware, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 1000 pieces per style per finish.
The failures here are predictable: unclear responsibility when a defect shows up after washing, or minimum order quantities far above what a growing brand can absorb. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Webbing |
|---|---|
| Width | 20 mm |
| Type | jacquard webbing |
| Base material | Viscose |
| Finish / process | Heat Transfer Printing |
| Colour options | 8 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 1000 pieces per style per finish |
| Sampling | 12 working days, 3 days per revision |
| Bulk lead time | 25-40 days after approval |
| Compliance | GB 18401 safety classification with GB/T 29862 fibre labelling; CPSIA lead and phthalate testing |
| Ship to | Shanghai or Shenzhen (Mainland China) |
What buyers can customise
- UV Printing — available on Viscose, quoted per position and per colour.
- Heat-Cut Edge — available on Viscose, quoted per position and per colour.
- Mercerised Finish — available on Viscose, quoted per position and per colour.
- Rubber Coating — available on Viscose, quoted per position and per colour.
- Sewn Edge — available on Viscose, quoted per position and per colour.
- Laser Engraving — available on Viscose, quoted per position and per colour.
- Anti-Rust Treatment — available on Viscose, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed width
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with heat transfer printing applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same edge stiffness.
FAQ
What packing options are available?
Bulk packed, carded, or packed to your own size and design ratio with barcodes applied.
What is the minimum order?
Programmes start at 1000 pieces per style per finish. Mixed sizes are fine within one style.
How long does sampling take?
A first sample takes 12 working days, and each revision about 3 days.
Can you match a reference sample?
Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.
Start your webbing programme
If you already have a supplier, send us the last problem you had with them. That is usually where we start.
