Custom Rhinestone in Acrylic Rhinestone with Sewn Edge for Outerwear and Jacket Programmes

Custom Rhinestone — Acrylic Rhinestone with Sewn Edge

We supply rhinestone to garment factories and brands, built in Acrylic Rhinestone with sewn edge for e-commerce and small-batch brands. On a trim like this the specification that decides the outcome is facet and foil consistency so the panel sparkles evenly, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 3000 pieces per style per finish.

The failures here are predictable: inconsistent sizing between production runs, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GB 18401 safety classification with GB/T 29862 fibre labelling so the shipment clears instead of sitting at port while your selling season passes.

Specification

What buyers can customise

• Rubber Coating — available on Acrylic Rhinestone, quoted per position and per colour.
• Black Oxide — available on Acrylic Rhinestone, quoted per position and per colour.
• Gold Plating — available on Acrylic Rhinestone, quoted per position and per colour.
• Mirror Polish — available on Acrylic Rhinestone, quoted per position and per colour.
• Brushed Finish — available on Acrylic Rhinestone, quoted per position and per colour.
• Epoxy Dome — available on Acrylic Rhinestone, quoted per position and per colour.
• Overlocked Edge — available on Acrylic Rhinestone, quoted per position and per colour.

How we produce it

1. Drawing or reference sample review, with size and finish confirmed
2. Material selection and a finish sample or strike-off
3. Prototype made to the agreed size
4. Fit and wash test on the actual garment fabric, then a pre-production sample
5. Bulk run with sewn edge applied under controlled settings
6. In-line inspection, final AQL 2.5 inspection and packing to your ratio

Where it is used

• Denim and workwear — hard-wearing finishes that survive industrial washing
• Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
• Childrenswear and schoolwear — tested to the destination's safety standard
• Bridal and eveningwear — small runs with hand-finished detail
• Uniform and corporate programmes — repeatable spec held on file for reorders

Packing, testing and delivery

Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for EN 71 part 3 for decorative components are prepared for the destination market. We ship to Shanghai or Shenzhen with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same facet and foil consistency so the panel sparkles evenly.

FAQ

What is the minimum order?

Programmes start at 3000 pieces per style per finish. Mixed sizes are fine within one style.

How long does sampling take?

A first sample takes 7 working days, and each revision about 3 days.

Can you match a reference sample?

Yes. Send the trim and we match material, finish and shade, then confirm on a pre-production sample before bulk.

How do you control colour on reorders?

The approved reference and the bulk standard are retained, and every reorder is checked against them before shipment.

Start your rhinestone programme

If you already have a supplier, send us the last problem you had with them. That is usually where we start.