Custom Eyelet — TPU with Injection Moulding
We supply eyelet to garment factories and brands, built in TPU with injection moulding for uniform and corporate programmes. On a trim like this the specification that decides the outcome is plating that survives washing and contact with skin, so that is agreed in writing before bulk — not discovered when the first carton is opened on the line. Programmes start at 5000 pieces per style per finish.
The failures here are predictable: colour drift between the approved sample and the bulk trim, or unclear responsibility when a defect shows up after washing. We lock material, finish, dimension and tolerance before bulk, and prepare GSO conformity with Arabic labelling so the shipment clears instead of sitting at port while your selling season passes.
Specification
| Product | Eyelet |
|---|---|
| Inner diameter | 4 mm |
| Type | toothed washer eyelet |
| Base material | TPU |
| Finish / process | Injection Moulding |
| Colour options | 24 Pantone-matched shades |
| Packing | boxed sets |
| MOQ | 5000 pieces per style per finish |
| Sampling | 10 working days, 4 days per revision |
| Bulk lead time | 15-30 days after approval |
| Compliance | GSO conformity with Arabic labelling; CPSIA lead and phthalate testing |
| Ship to | Jebel Ali (the Middle East) |
What buyers can customise
- Gold Plating — available on TPU, quoted per position and per colour.
- Rose Gold Plating — available on TPU, quoted per position and per colour.
- Paint Spray — available on TPU, quoted per position and per colour.
- Anti-Rust Treatment — available on TPU, quoted per position and per colour.
- Soft Enamel Fill — available on TPU, quoted per position and per colour.
- Chrome Plating — available on TPU, quoted per position and per colour.
- Rubber Coating — available on TPU, quoted per position and per colour.
How we produce it
- Drawing or reference sample review, with size and finish confirmed
- Material selection and a finish sample or strike-off
- Prototype made to the agreed inner diameter
- Fit and wash test on the actual garment fabric, then a pre-production sample
- Bulk run with injection moulding applied under controlled settings
- In-line inspection, final AQL 2.5 inspection and packing to your ratio
Where it is used
- Denim and workwear — hard-wearing finishes that survive industrial washing
- Outerwear and tailoring — matched to the shell fabric so it drapes with the garment
- Childrenswear and schoolwear — tested to the destination's safety standard
- Bridal and eveningwear — small runs with hand-finished detail
- Uniform and corporate programmes — repeatable spec held on file for reorders
Packing, testing and delivery
Trims are packed to the ratio you specify — by size, by colour or by garment set — with barcodes applied where the line needs them. Test reports for CPSIA lead and phthalate testing are prepared for the destination market. We ship to Jebel Ali with the commercial invoice, packing list and certificate of origin, and hold the approved reference so reorders reproduce the same material, the same finish and the same plating that survives washing and contact with skin.
FAQ
How long does sampling take?
A first sample takes 10 working days, and each revision about 4 days.
Can you do small runs across many designs?
Yes — many studio and boutique programmes run small quantities across a wide design set.
Which compliance documents do you provide?
We prepare CPSIA lead and phthalate testing and the supporting test reports for the destination market.
What is the minimum order?
Programmes start at 5000 pieces per style per finish. Mixed sizes are fine within one style.
Start your eyelet programme
Send us a reference sample, a drawing or a spec sheet and we will come back with material options, a costing and a sampling timetable.
